Clean your Fitbit with a soft, damp cloth and dry it when ready

The safest way to clean a Fitbit is to use a lint-free cloth slightly dampened with water, then dry it right away with another dry cloth. Do not soak the device, do not use soap or cleaning products, and do not let water sit on it. Most Fitbits are water-resistant but not waterproof — water can seep into seams and damage the battery or electronics if it stays there.

For the band, you can use a slightly soapy cloth if the band is removable (most newer models are). Rinse with a damp cloth and dry completely. If the band is not removable, treat it the same way you treat the device itself: damp cloth, when ready drying, no soap.

Clean your Fitbit once a week or whenever you notice dirt, sweat buildup, or discoloration. Regular light cleaning prevents grime from hardening and keeps the sensors working properly.

Key Takeaways

  • Use only a lint-free cloth dampened with water, then dry when ready — never soak your Fitbit or use soap on the device itself.
  • Removable bands can be cleaned with a slightly soapy cloth, but the tracker body should only touch water-dampened cloth.
  • Pay special attention to the underside where the sensors sit, as sweat and dirt buildup there can interfere with heart rate and sleep tracking.
  • Let your Fitbit air-dry completely before wearing it again, especially if water got near the charging contacts.

Cleaning the sensor area on the back

The underside of your Fitbit has sensors that track your heart rate and other metrics. These sensors sit flush against your skin and collect sweat, dead skin cells, and dirt over time. This buildup can make readings less accurate and cause skin irritation.

Dampen a cloth with water and gently wipe the entire back of the device, paying extra attention to the sensor area. Use a soft touch — you are not scrubbing. If you see stubborn residue, let the damp cloth sit on that spot for a few seconds, then wipe gently. Dry the back completely with a dry cloth before putting the Fitbit back on your wrist.

If you wear your Fitbit 24/7, clean the back at least twice a week. If you take it off at night, once a week is usually enough.

Removing and cleaning a removable band

Most Fitbit models made in the last three years have bands that slide off or pop out. Check your device manual to see how your band attaches — some slide horizontally, others pop straight out.

Once the band is off, you can wash it under warm running water with a small amount of mild soap. Use your fingers to rub away sweat and dirt, then rinse thoroughly until no soap remains. Lay the band flat on a clean, dry cloth and let it air-dry completely — at least 30 minutes — before snapping it back on. Do not use a hair dryer or place it in direct sunlight, as heat can warp the material.

While the band is off, wipe down the tracker body itself with a damp cloth as described above. This is a good time to clean both the front screen and the back sensors.

What to avoid when cleaning

Do not use alcohol, bleach, vinegar, or any chemical cleaner on your Fitbit. These can damage the screen, corrode the metal contacts, or degrade the band material. Do not scrub hard or use abrasive cloths like paper towels or scouring pads — these can scratch the screen or wear away the band finish.

Do not submerge your Fitbit in water, even though it is water-resistant. Water-resistant means it can handle splashes and brief exposure, not prolonged submersion. Do not use a dishwasher, washing machine, or ultrasonic cleaner. Do not point a hair dryer at it or leave it in direct sunlight to dry, as heat can damage the battery.

If your Fitbit gets wet during a swim or shower, dry it as soon as you get out. If water gets inside the device and you notice condensation under the screen, do not charge it — let it air-dry for 24 hours first, then try charging.

Cleaning the charging contacts

The charging contacts on your Fitbit can accumulate dust and corrosion, which can prevent the device from charging properly. These contacts are usually on the back or side of the device, depending on your model.

Dampen a cloth very slightly with water and gently wipe the charging contacts. If you see green or white discoloration (oxidation), dampen the cloth a bit more and rub gently until the contacts look clean and shiny again. Dry thoroughly with a dry cloth before charging.

If your Fitbit is not charging even after cleaning the contacts, let both the device and the charger sit in a dry place for 24 hours, then try again. Sometimes moisture in the contacts prevents charging until it evaporates.

Preventing buildup so you clean less often

The less sweat and dirt that builds up, the less often you need to clean. If you work out, rinse your Fitbit with plain water as soon as you finish and dry it when ready. If you wear it all day and night, take it off for 30 minutes each day to let your skin breathe and to give the device a chance to dry out.

If you live in a humid climate or sweat heavily, consider cleaning the sensor area twice a week instead of once. Sweat left on the device can corrode the metal components over time and cause skin irritation.

Store your Fitbit in a cool, dry place when you are not wearing it. Do not leave it in a gym bag or car where moisture can accumulate.

Frequently Asked Questions

Can I clean my Fitbit under running water?

You can rinse the band under running water if it is removable, but do not hold the tracker body under running water. Use a damp cloth for the device itself. Running water can force moisture into seams and damage the electronics.

What should I do if water gets inside my Fitbit?

If you see condensation under the screen or the device stops responding, do not charge it. Place it in a dry location for 24 hours and let it air-dry completely. After 24 hours, try charging it again. If it still does not work, contact Fitbit support.

How often should I clean my Fitbit?

Once a week is standard for most people. If you work out daily, swim, or sweat heavily, clean it twice a week. The more often you clean, the better your sensors will track and the less likely you are to develop skin irritation.

Can I use hand sanitizer to clean my Fitbit?

No. Hand sanitizer contains alcohol, which can damage the screen and corrode the metal contacts. Stick to water and a lint-free cloth only.

Is it safe to wear my Fitbit while swimming?

Most Fitbits are water-resistant and safe for swimming, but dry them thoroughly afterward. Do not leave water sitting on the device — wipe it dry with a cloth as soon as you get out of the pool or ocean.