The Charge 2 is water-resistant, not waterproof — and that distinction matters
The Fitbit Charge 2 has a water resistance rating of 5 ATM, which means it can handle splashes, rain, and brief immersion in water up to 50 meters deep. However, it is not waterproof. Water-resistant and waterproof are different: water-resistant means the device can tolerate some water exposure, but waterproof means it is sealed against all water entry. The Charge 2 will survive a shower or a quick dip in a pool, but it is not designed for extended swimming, diving, or water sports.
The 5 ATM rating comes from the International Organization for Standardization (ISO) and is used across the watch and fitness tracker industry. At this level, the device can be submerged briefly during normal activities like washing your hands or swimming laps in a pool for short periods. Fitbit's own documentation states the Charge 2 is suitable for swimming, but not for diving or water sports that involve high-impact water contact or prolonged submersion.
Key Takeaways
- The Charge 2 has a 5 ATM water resistance rating, meaning it can handle splashes, showers, and brief swimming but is not waterproof.
- You can wear the Charge 2 while swimming laps in a pool, but remove it before diving, snorkeling, or water sports with high-impact contact.
- Saltwater exposure (ocean swimming) can damage the device over time, so rinse it with fresh water when ready after saltwater use.
- The device will continue to track your heart rate and steps while submerged, but extended water exposure increases the risk of seal failure.
What 5 ATM water resistance actually means for daily use
A 5 ATM rating is the middle ground in water resistance. It is higher than devices rated 3 ATM (splash-resistant only) but lower than 10 ATM (suitable for snorkeling) or 20 ATM (suitable for diving). For the Charge 2, this means you can confidently wear it in the shower, wash your hands while wearing it, and swim in a pool without worrying about when ready damage.
The rating assumes normal use, not stress testing. A quick dip is fine; holding the device underwater for several minutes or repeatedly submerging and removing it in the same session increases the chance of water seeping past the seals. If you swim regularly, the repeated pressure changes and temperature shifts from pool water can gradually wear down the seals, making the device more vulnerable over time.
When you should remove the Charge 2 before water exposure
Take off your Charge 2 before diving, snorkeling, or any water sport where the device experiences sustained pressure or high-impact water contact. Diving exposes the tracker to pressures far beyond 5 ATM, and water sports like surfing, jet skiing, or whitewater rafting involve repeated submersion and rapid pressure changes that can force water past the seals.
Ocean swimming is a gray area. Saltwater is more corrosive than fresh water and can damage the internal components and battery contacts even if water does not when ready enter the device. If you do swim in the ocean while wearing the Charge 2, rinse it thoroughly with fresh water as soon as you get out, then dry it completely. Do not assume the 5 ATM rating protects it from salt damage — it does not.
How to care for your Charge 2 after water exposure
After swimming or showering, pat the Charge 2 dry with a soft cloth. Pay special attention to the seams where the band connects to the main body and around the charging contacts on the back. If water droplets remain in these areas, they can corrode the metal contacts or seep into the device over time.
If you accidentally submerge the Charge 2 deeper than intended or for longer than a few minutes, remove it when ready and let it air-dry for at least 24 hours in a warm, dry place before wearing it again. Do not use a hair dryer or place it near direct heat, as this can damage the battery and internal components. If the screen fogs up or you notice condensation inside the display, the seal may have failed — contact Fitbit support for repair options.
Signs that the water resistance seal may be failing
Watch for condensation or fogging inside the display that does not clear after a few hours of air-drying. This is the clearest sign that water has entered the device. You may also notice the screen becoming unresponsive in certain areas, or the device shutting off unexpectedly after water exposure — both indicate internal moisture damage.
If the Charge 2 stops charging or charges very slowly after water exposure, the charging contacts may be corroded. Corrosion typically appears as white, green, or blue discoloration on the metal contacts on the back of the device. In most cases, once water has damaged the internal components, the device cannot be repaired and will need to be replaced.
Comparing the Charge 2 to other Fitbit models
The Charge 2 is one of Fitbit's older models, released in 2016. Newer Fitbit trackers like the Charge 5 and Inspire 3 also have 5 ATM water resistance, so they offer the same level of protection. The Fitbit Ionic and Versa smartwatches have 5 ATM ratings as well. If you need a device rated for deeper water exposure, the Fitbit Aqua is specifically designed for swimming and water sports, though it is no longer in active production.
If you swim frequently or participate in water sports, consider upgrading to a device with a higher water resistance rating or one specifically marketed for water activities. The difference in cost is usually modest, and the peace of mind is worth it if you are regularly exposing your device to water.
Frequently Asked Questions
Can I wear my Charge 2 while swimming laps in a pool?
Yes, the 5 ATM rating means you can wear it during pool swimming. However, avoid diving, jumping into the pool, or staying submerged for extended periods. Rinse it with fresh water and dry it thoroughly after your swim.
What happens if I accidentally drop my Charge 2 in the toilet or bathtub?
Remove it when ready and dry it. A brief accidental submersion in fresh water should not cause damage. If it was submerged for more than a few seconds, let it air-dry for 24 hours before wearing it again. If condensation appears inside the screen, the seal may have failed.
Is the Charge 2 safe to wear in the ocean?
The 5 ATM rating covers fresh water, not saltwater. Saltwater is corrosive and can damage the device even if water does not enter the case. If you do swim in the ocean, rinse the Charge 2 with fresh water when ready and dry it completely.
Can I shower with my Charge 2 on?
Yes, the Charge 2 is designed to handle shower water. The warm water and steam from a typical shower fall well within the 5 ATM rating. Just make sure to dry it afterward, especially around the seams and charging contacts.
Will the Charge 2 track my heart rate while I am swimming?
Yes, the heart rate sensor continues to work while the device is submerged. However, water can sometimes interfere with the optical sensor, so readings may be less accurate during swimming than during land-based activities.