The Scanner Room Entrance and What You Need

The Scanner Room in Subnautica sits inside the Aurora, the massive alien ship that crashes near your starting point. To get inside, you need a Prawn Suit with a drill arm and a Thermal Charger module. The drill arm lets you break through the sealed door, and the thermal charger keeps your suit powered while you work. Without both, you cannot enter.

The entrance is on the exterior of the Aurora's starboard side, facing away from the island. You will see a sealed bulkhead door with a glowing orange outline. This door is what you drill through. The room itself contains the scanner console and a data bank with important blueprints, so the trip is worth the preparation.

Key Takeaways

  • You must build a Prawn Suit and equip it with both a drill arm and a Thermal Charger module before attempting entry.
  • The Scanner Room entrance is a sealed bulkhead door on the outside of the Aurora's starboard hull, marked by an orange outline.
  • You drill through the door using the Prawn Suit's drill arm, which takes time but does not require any special items or tools beyond the suit itself.
  • Once inside, you can access the scanner console and read the data bank entries, which unlock blueprints for the Stasis Rifle and other late-game items.

Building and Equipping Your Prawn Suit

The Prawn Suit is a large exosuit you craft in the Prawn Suit Fabricator, which you find in the Aurora itself or build in your base. You need Titanium, Aerogel, and Plasteel to build the suit. Titanium comes from small wrecks and outcrops. Aerogel drops from Jellyshroom Cave and Ghost Leviathan wrecks. Plasteel requires a Fabricator and a recipe you unlock from scanning.

Once the suit is built, you equip the drill arm in one of the suit's two arm slots. The drill arm itself requires Titanium, a Diamond, and a Lithium to craft. The Thermal Charger module goes into the suit's upgrade slot and requires Nickel Ore, Kyanite, and a Plasteel Ingot. Both items are crafted in the Fabricator.

Before you leave your base, make sure your Prawn Suit is fully charged. The Thermal Charger will recharge your suit while you are near heat sources like the Aurora's interior, but you need enough power to reach those areas first.

Locating the Scanner Room Door on the Aurora

The Aurora is a wreck in the Safe Shallows, roughly 1,200 meters from your starting lifepod. Swim or drive toward the massive ship until you see its hull. The Scanner Room entrance is on the starboard side — the right side when you face the ship's front. Look for the sealed bulkhead door with the orange glowing outline.

The door sits at a depth of about 180 to 200 meters, so you will need a vehicle or depth upgrades to reach it safely. The Prawn Suit itself can handle this depth without upgrades, but you should still move carefully because the Aurora is surrounded by dangerous fauna and radiation zones.

If you cannot find the door when ready, swim around the starboard side of the ship's exterior. The door is not hidden, but the Aurora is large enough that it takes a moment to locate. Once you see the orange outline, you have found the right spot.

Drilling Through the Sealed Door

Position your Prawn Suit directly in front of the sealed door so the drill arm faces it. set up the drill arm using the right mouse button (or the equivalent on your controller). The drill will begin breaking through the door automatically. This process takes roughly 30 to 45 seconds, depending on your game settings.

While drilling, your suit will lose power steadily. This is where the Thermal Charger module becomes essential — it recharges your suit as you work, so you do not run out of power mid-drill. If you do not have the Thermal Charger, you will drain your battery before the door breaks, and you will have to retreat and recharge.

Do not move or change direction while drilling. If you move away from the door, the drilling stops and you have to start over. Once the door breaks, it stays open, so you only have to drill it once per playthrough.

Entering the Scanner Room and What You Find Inside

After the door breaks, pilot your Prawn Suit through the opening into the Scanner Room. The interior is a large chamber with the scanner console in the center and a data bank on one wall. You can exit your suit and walk around inside, or stay in the suit — both work fine.

The scanner console itself does not give you anything directly, but reading the data bank entries unlocks blueprints for the Stasis Rifle and the Depth Module Mark 2. These are high-tier items that you will need later in the game. The data entries also provide story context about the Aurora and the planet.

The room is safe once you are inside — no enemies spawn in here. Take your time reading the entries and collecting any loose items. When you are done, you can pilot your suit back out through the same door you drilled.

Avoiding Common Problems During Entry

The most common mistake is attempting the drill without a Thermal Charger. Your suit will run out of power before the door breaks, and you will be stuck outside with no way to recharge nearby. Always equip the Thermal Charger before you leave your base.

Another issue is radiation damage. The Aurora's exterior is radioactive, and your Prawn Suit does not have radiation protection by default. You can craft a Radiation Suit and wear it while piloting, or you can move quickly through the radioactive zone. The drill process is fast enough that radiation damage is usually minor if you are already inside the suit.

If your drill arm breaks or you lose it somehow, you cannot enter the Scanner Room without building a new one. Keep a backup drill arm in your base or carry the materials to craft one if you plan to make multiple trips.

Frequently Asked Questions

Can I enter the Scanner Room without a Prawn Suit?

No. The sealed door requires the Prawn Suit's drill arm to open. You cannot break through it with any handheld tool or explosive. You must build and equip a Prawn Suit before attempting entry.

What happens if my Prawn Suit runs out of power while I am drilling?

The drill stops when ready, and the door remains partially broken. You will have to pilot your suit back to a charging station, recharge fully, and return to finish drilling. This is why the Thermal Charger module is essential — it prevents this problem by recharging you while you work.

Do I need radiation protection to enter the Scanner Room?

The exterior of the Aurora is radioactive, but the Scanner Room interior is safe. You should wear a Radiation Suit or move quickly through the radioactive zone to minimize damage. Once you are inside the room, radiation is no longer a threat.

Can I use the Scanner Room console to scan things?

The console itself does not function as a scanner. It is a story element and a data bank. The blueprints you unlock from reading the data entries are the main reward for reaching this location.

What if the door will not break even though I am drilling?

Make sure you are directly in front of the door and that your drill arm is equipped and active. If the door still will not break, check that your Prawn Suit has power. A suit with very low power may not drill effectively. Return to your base, recharge fully, and try again.