The GoPro Hero 3 charges through a micro-USB port on the side of the camera, using any standard micro-USB cable and power adapter
The GoPro Hero 3 does not have a dedicated charging dock. Instead, you plug a micro-USB cable directly into the port on the camera's side, then connect the other end to a USB power adapter. The camera itself stays in your hand or on a surface while it charges — you do not remove the battery.
Charging takes roughly two to three hours from empty to full, depending on the power adapter you use. A standard 1-amp adapter (the kind that comes with many phones) will charge slower than a 2-amp adapter. The camera will continue to work while plugged in, though the battery will charge faster if you turn it off.
Key Takeaways
- The micro-USB port is located on the side of the Hero 3 camera body, and you plug the cable directly into the camera rather than using a separate dock.
- Any standard micro-USB cable works, but a 2-amp USB power adapter charges the battery faster than a 1-amp adapter.
- The battery stays inside the camera during charging — you do not remove it or use an external charger.
- Turning off the camera while charging reduces the time needed to reach a full charge.
- A full charge from empty takes two to three hours under normal conditions.
What cable and adapter you need
You need a micro-USB cable and a USB power adapter. The micro-USB end plugs into the camera; the standard USB end plugs into the adapter. If you own any Android phone or tablet from the past decade, you likely have a micro-USB cable already in a drawer.
The power adapter can be a wall charger (the kind you plug into an outlet), a car charger, or even a USB port on a computer. The Hero 3 will charge from any of these, though a wall charger or car charger is faster than a computer USB port because they deliver more power. A 2-amp adapter is ideal; a 1-amp adapter works but takes longer.
GoPro sells official micro-USB cables and adapters, but third-party options from reputable brands work just as well and often cost less. Avoid very cheap cables from unknown sellers, as they can damage the port or charge slowly.
How to find and use the charging port
The micro-USB port is on the right side of the camera when you are looking at the screen. It is a small rectangular opening, roughly the size of a grain of rice. The port sits next to the HDMI port, which is slightly larger and rectangular.
To charge, insert the micro-USB cable into the port until you feel it click or seat firmly. The cable should not require force — if you are pushing hard, you may have the wrong angle. Once the cable is in, connect the other end to your power adapter and plug the adapter into an outlet, car charger, or computer USB port.
A small light on the camera will turn on or change color to show charging status. On the Hero 3, a red light usually means the battery is charging, and the light may turn off or change when the battery is full. Check your specific model's manual for the exact light behavior, as it varies slightly between Hero 3 versions.
Charging time and battery life
A completely empty battery takes two to three hours to reach full charge with a standard 2-amp adapter. If you use a 1-amp adapter (like an older phone charger), add another hour or more to that time. Turning off the camera while it charges will shorten the time by roughly 30 minutes.
The Hero 3 battery is rated for about 60 to 90 minutes of recording time per charge, depending on the resolution and frame rate you use. Higher resolutions and frame rates drain the battery faster. If you are filming in 4K, expect closer to 60 minutes; at 1080p, you may get 90 minutes or more.
The battery itself lasts roughly 300 to 500 charge cycles before it begins to hold less charge. After two to three years of regular use, you may notice the battery does not last as long as it did when new. At that point, you can buy a replacement battery from GoPro or a third-party seller and swap it in yourself — the battery compartment is on the bottom of the camera.
Troubleshooting slow or failed charging
If the camera is not charging, first check that the cable is fully seated in the port. Wiggle it gently to make sure it is making contact. If the light does not turn on after 10 seconds, try a different power adapter — the one you are using may be faulty or delivering too little power.
Dirt or lint in the micro-USB port can block the connection. If you suspect this, turn off the camera and use a small flashlight to look into the port. If you see debris, gently clean it out with a dry cotton swab or a small brush. Do not use water or liquid cleaners, as they can damage the port.
If the camera still will not charge after trying a different cable and adapter, the port itself may be damaged. This is rare but can happen if the cable was pulled hard or the port was struck. In that case, contact GoPro support or visit a repair shop, as the port may need to be replaced.
Charging while traveling
For trips, bring a micro-USB cable and a portable USB power bank rated for at least 2 amps. A power bank lets you charge the camera anywhere without finding an outlet. Many modern power banks have two or more USB ports, so you can charge the camera and your phone at the same time.
If you are traveling internationally, bring a universal USB power adapter that works with outlets in the countries you are visiting. The micro-USB standard is the same worldwide, so any adapter that outputs USB power will work with your Hero 3.
Consider bringing a second battery as a backup. You can charge one battery while using the other, which doubles your recording time without needing to find an outlet. Replacement batteries are inexpensive and small enough to fit in any camera bag.
When to replace the battery
Replace the battery if it no longer holds a charge for the full rated time, or if it drains rapidly even after a full charge. A battery that is two to three years old and used regularly will often show these signs. You do not need to wait until the battery is completely dead — replacing it before it fails completely will save you from losing footage mid-shoot.
To replace the battery, turn off the camera and open the battery compartment on the bottom. Slide the old battery out and slide the new one in, making sure the contacts face the right direction. Close the compartment and charge the new battery before your first use.
Frequently Asked Questions
Can I charge the GoPro Hero 3 with a phone charger?
Yes, if the phone charger has a USB port and a micro-USB cable. Most Android phone chargers from the past ten years work. A charger rated for 2 amps will charge faster than a 1-amp charger, but both will work.
How do I know when the battery is fully charged?
The charging light on the camera will turn off or change color when the battery is full. The exact behavior depends on your Hero 3 model, so check the manual that came with your camera. You can also unplug the cable after two to three hours — that is usually enough time for a full charge.
Can I use the camera while it is charging?
Yes, the Hero 3 will record and operate while plugged in. However, the battery will charge faster if you turn the camera off. If you need to use it while charging, the battery will still charge, just more slowly.
What should I do if the micro-USB port is loose or damaged?
A loose port may still work if the cable is fully inserted and makes contact. If the port is visibly cracked or the cable falls out easily, the port may need professional repair. Contact GoPro support or a camera repair shop for options.
Is it safe to leave the camera charging overnight?
Yes, the Hero 3 will not overcharge. Once the battery is full, charging stops automatically. Leaving it plugged in overnight will not damage the battery or camera, though it is not necessary — two to three hours is enough for a full charge.