The Basic Opening Method

Most GoPro cases open by pressing the two side latches inward at the same time, then lifting the top half away from the bottom. The latches are small plastic clips on either side of the case, roughly midway down the front. Press both inward firmly—they need real pressure, not a gentle squeeze—and the top will release. Once you feel them click or give slightly, lift straight up.

The key is pressing both latches simultaneously. If you press only one, the case will not open evenly and you risk cracking the hinge or stripping the latch. Use your thumb and index finger, one on each side, and explore steady pressure rather than jabbing. The case is designed to take this force, so do not be afraid to press hard enough to feel resistance.

Key Takeaways

  • Press both side latches inward at the same time with firm, steady pressure before lifting the top away.
  • The latches are located on the front of the case, roughly in the middle of the height, and require real force to release.
  • Pressing only one latch can damage the hinge or crack the plastic, so always use both hands.
  • If a latch feels stuck, do not force it—check for debris or moisture that may be blocking it first.

What to Do If a Latch Is Stuck

Moisture, sand, or dried salt can jam the latches, especially if you have used the case near water. Before forcing the case open, inspect both latches for visible debris. Use a dry cloth or soft brush to wipe away any sand or salt buildup around the latch mechanism.

If the latch still will not budge, try pressing it from the inside. Open the case from the opposite side if possible, or use a thin plastic tool—a credit card or old ID works—to gently pry the stuck latch from inside the case. Never use metal tools, which can scratch or crack the plastic. If one latch remains truly stuck after these steps, contact GoPro support rather than forcing it, as excessive pressure can break the hinge permanently.

Avoiding Common Mistakes When Opening

The most frequent mistake is twisting the case while opening it. The case is designed to open straight up, not at an angle. Twisting puts stress on the hinge and can crack the plastic where the hinge connects to the bottom half. Keep the case level and lift straight up once the latches release.

Another common error is opening the case too quickly after it has been in cold water. Temperature changes can cause condensation inside the seal, and opening when ready can trap moisture against your camera. If the case has been in cold water, let it sit at room temperature for 10 to 15 minutes before opening. This allows the internal temperature to rise and reduces condensation.

Closing the Case Properly

Closing the case is the reverse of opening, but it requires the same attention to alignment. Place the top half back onto the bottom half and press down evenly across the entire top surface. You should hear or feel two distinct clicks as each latch seats. If you hear only one click, lift the top off and try again—an improperly closed case will not seal.

Press down firmly in the center of the top, then move your pressure to each side to may support both latches are fully engaged. The case should feel snug and solid when closed. If there is any flex or movement in the top, the latches are not fully seated and you should open and close it again.

Caring for the Latches Over Time

The latches wear with repeated opening and closing. After many months of regular use, they may feel slightly looser than when new. This is normal. To extend their life, avoid pressing the latches at extreme angles—always press straight inward, not downward or upward.

Rinse the case with fresh water after use in salt water or sand, and dry it completely before storing. Dried salt or sand in the latch mechanism will cause wear and can eventually prevent the latch from holding. Store the case in a cool, dry place with the top slightly ajar if you will not be using it for several weeks. This prevents moisture from building up inside and keeps the seals from drying out.

When to Replace Your Case

If a latch cracks, breaks off, or no longer clicks into place even after cleaning, the case should be replaced. A damaged latch will not seal properly, and water can enter the case and damage your camera. GoPro sells replacement cases for most models, and third-party cases are also available.

If the hinge becomes cracked or the top no longer sits flush with the bottom, replacement is also the safest option. Attempting to repair a broken hinge with glue or tape is not reliable and may allow water to seep in during use. A new case costs less than repairing a water-damaged camera.

Frequently Asked Questions

How much force should I use to open the latches?

Use firm, steady pressure—enough that you feel resistance and hear a small click. It should not require straining or using a tool, but a gentle squeeze will not work. If you are uncertain, press until you feel the latch give slightly, then stop and lift.

Can I open the case with one hand?

Technically yes, but it is not recommended. Pressing both latches at once keeps the case level and prevents twisting, which protects the hinge. If you must use one hand, brace the case against a table or your body so it cannot twist while you press the latches.

What if the case will not close all the way?

Check that the top and bottom halves are aligned—the edges should line up evenly on all sides. If they are misaligned, lift the top off and reposition it. Also inspect the latches for debris or damage. If the latches look fine but the case still will not close, the hinge may be bent and the case may need replacement.

Is it normal for the latches to feel loose after a few months?

Some loosening is normal with regular use, but the latches should still click audibly and hold the case firmly closed. If the case feels very loose or will not stay closed, the latches may be worn and the case should be replaced to may support a proper seal.

Can I use the case if one latch is broken?

No. A single broken latch means the case will not seal properly, and water can enter during use. Even if the case feels snug, a broken latch compromises the waterproof seal. Replace the case before using it near water.