Charging Your Hero3 With the Standard USB Cable

The GoPro Hero3 charges through a micro-USB port located on the side of the camera body. You can charge the camera while it is powered on or off, though charging happens faster when the camera is off. Plug the micro-USB cable into the port, then connect the other end to any standard USB power adapter—the kind that came with your phone works fine, or any 5-volt adapter rated for at least 1 amp.

The camera will show a red light while charging and a green light when fully charged. A full charge from empty takes roughly 2 to 3 hours using a standard 1-amp adapter. If you use a higher-amperage adapter (2 amps or more), charging completes faster, usually in 1.5 to 2 hours. The camera will not overheat or suffer damage from a faster charger—it only draws the power it needs.

You do not need to remove the battery to charge the camera. The Hero3 charges the battery inside the camera body directly through the USB port, so there is no separate charging dock or external charger required unless you choose to buy one.

Key Takeaways

  • The Hero3 charges through the micro-USB port on the side of the camera using any standard USB power adapter.
  • A full charge takes 2 to 3 hours with a 1-amp adapter, or 1.5 to 2 hours with a 2-amp adapter.
  • The camera shows a red charging light and a green light when fully charged.
  • You can charge the camera while it is powered on, though charging is faster when the camera is off.
  • Higher-amperage adapters (2 amps or more) speed up charging without damaging the battery.

Using a Faster USB Power Adapter

If you are in a hurry, a 2-amp USB adapter cuts charging time roughly in half compared to the standard 1-amp adapter. Many modern phone chargers are rated for 2 amps or higher. Check the label on your adapter—it will say something like "5V 2A" or "5V 2.1A". The Hero3 battery is small enough that even a 2.4-amp adapter (common on iPad chargers) will not cause problems.

The camera's charging circuit is designed to accept power safely up to 2 amps without risk of overcharging or battery damage. Anything beyond 2 amps is unnecessary—the camera straightforward will not draw more than it needs. If you regularly charge on the go, keeping a 2-amp adapter in your camera bag saves time without any downside.

Charging From a Computer or Power Bank

You can charge the Hero3 from any USB port on a computer, though it will be slower. Most computer USB ports supply only 0.5 amps, so expect charging to take 4 to 5 hours from a desktop or laptop. This method works in a pinch but is not practical for regular use.

A portable power bank with a USB output works well for charging in the field. Choose a power bank rated for at least 1 amp output. Many modern power banks are rated for 2 amps or higher, which will charge your camera at the same speed as a wall adapter. This is useful if you are filming all day and need to top up the battery between sessions without access to a wall outlet.

Troubleshooting Charging Problems

If the camera does not show a charging light when you plug it in, first try a different USB cable. Micro-USB cables wear out and the connector can become loose or corroded. If a different cable works, the original cable is faulty and should be replaced.

If the camera still does not charge with a new cable, try a different power adapter. Some adapters, especially very old ones or cheap third-party models, may not deliver enough power. A standard phone charger rated for at least 1 amp almost always works.

If the camera charges with some adapters but not others, the USB port on the camera may have debris inside it. Power off the camera and use a small flashlight to look into the port. If you see lint or dirt, gently clean it out with a dry cotton swab or a small brush. Do not use liquid cleaners or force anything into the port.

If the camera still will not charge after trying multiple cables and adapters, the internal charging circuit may be damaged. At that point, the camera will need service or replacement.

How Long the Battery Lasts Between Charges

Once fully charged, a Hero3 battery lasts roughly 1.5 to 2 hours of continuous recording in standard mode. Battery life is shorter in high-resolution modes (1080p at 60 frames per second uses more power than 720p at 30 frames per second) and longer in low-power modes. Cold temperatures also drain the battery faster—expect 20 to 30 percent less runtime in freezing conditions.

If you plan to film for longer than 2 hours, bring a second charged battery or a power bank. The Hero3 battery is not user-replaceable without opening the camera, so you cannot swap batteries in the field the way you can with some other cameras.

Storing the Camera and Battery Long-Term

If you are not using the Hero3 for more than a few weeks, charge it to about 50 percent before storing it. A battery stored at full charge or completely empty will lose capacity over time. Store the camera in a cool, dry place—not in a hot car or damp basement. A temperature between 50 and 80 degrees Fahrenheit is ideal.

Before using the camera again after storage, charge it fully and let it sit powered off for 10 minutes. This allows the battery management circuit to recalibrate and ensures you get accurate battery readings.

Frequently Asked Questions

Can I use a fast charger meant for phones?

Yes. Phone chargers rated for 2 amps or even higher work safely with the Hero3. The camera only draws the power it needs, so a fast charger will not damage the battery. Charging will straightforward be faster than with a standard 1-amp adapter.

What if the red light stays on and never turns green?

Try unplugging the cable, waiting 30 seconds, and plugging it back in. If the light still does not change after 3 hours, the battery may be completely dead or the charging circuit may have a problem. Test with a different cable and adapter first. If neither works, the camera likely needs service.

Is it safe to charge the camera while recording?

Yes, you can charge while the camera is on and recording. However, charging is slower when the camera is powered on because some of the power goes to running the camera instead of the battery. For faster charging, power off the camera first.

How do I know when the battery is fully charged?

The light on the camera turns green when charging is complete. You can also unplug the cable and power on the camera—a full battery will show a full battery icon on the screen or in the viewfinder, depending on your display mode.

Can I charge the Hero3 with a wireless charger?

No. The Hero3 does not support wireless charging. It only charges through the micro-USB port with a wired cable.