The fastest way to power down your GoPro Hero
Press and hold the power button on the side of your camera for three seconds until the screen goes black and you hear a beep. The power button is the small circular button on the left side of the camera body. Hold it down — a quick tap will not turn the camera off; it will only put it into standby mode, where the screen sleeps but the camera still draws battery power.
You will see a brief animation on the screen showing the camera shutting down, then the display will go dark. Once the screen is completely black and stays black for two seconds, the camera is fully powered off. The LED light on the back of the camera will also turn off.
Key Takeaways
- Hold the power button for three full seconds — a quick press only puts the camera to sleep, not off.
- You will hear a beep and see the screen go black when the camera is shutting down.
- Standby mode still drains your battery, so power off completely if you are not using the camera for more than a few hours.
- If your camera is frozen or will not respond to the power button, remove the battery for 30 seconds and reinsert it.
The difference between standby mode and power off
A short tap of the power button puts your GoPro into standby mode. The screen goes dark, but the camera is still on and listening for voice commands or a remote trigger. In standby, your battery will drain slowly over hours, even if you are not recording.
Holding the power button for three seconds turns the camera completely off. No power is drawn except the tiny amount needed to keep the internal clock running. If you plan to leave your camera in a bag or on a shelf for more than a few hours, power it off completely to preserve battery life.
What to do if the power button is not responding
If your camera will not turn off when you hold the power button, the camera may be frozen. Remove the battery from the bottom of the camera by sliding the battery door open and pulling the battery straight out. Wait 30 seconds, then reinsert the battery and close the door. Press the power button again.
If the camera still will not respond, plug it into a USB charger and let it charge for at least 15 minutes. Sometimes a completely drained battery prevents the camera from responding to button presses. After charging, try the power button again.
Turning off the camera before removing the battery or memory card
Always power off your GoPro before you remove the battery or memory card. Removing either one while the camera is on can corrupt the files on your memory card or damage the camera's file system. Power off first, wait for the screen to go completely dark, then open the battery or memory card door.
If you need to swap batteries quickly during a shoot, use standby mode instead. Tap the power button once to put the camera to sleep, swap the battery, then tap the power button again to wake it up. The camera will be ready to record in seconds.
How to check the battery level before powering off
Before you turn off your camera, check the battery percentage on the screen. The battery icon appears in the top right corner of the display. If the battery is below 20 percent, charge the camera before your next use — a low battery can prevent the camera from powering on or recording properly.
If your camera is completely dead and will not turn on, plug it into a USB charger using the cable that came with your GoPro. The charging light on the camera will turn red while charging and green when fully charged. This usually takes one to two hours depending on the battery size.
Powering off when the camera is mounted or in a housing
You can power off your GoPro while it is mounted to a helmet, chest strap, or other accessory. The power button is still accessible on the side of the camera body. Press and hold it for three seconds as you normally would. The camera will shut down in its mounted position.
If your camera is inside a waterproof housing, you can still reach the power button through the housing. Press and hold the button on the outside of the case for three seconds. The button will depress slightly and trigger the power-off sequence inside the housing.
Frequently Asked Questions
Will my GoPro turn off automatically if I do not use it?
No, your GoPro will not turn off on its own. If you leave it on or in standby mode, the battery will continue to drain until it is completely dead. You must manually power off the camera by holding the power button for three seconds.
Does turning off the camera erase my videos or photos?
No. Powering off the camera does not erase any files. Your videos and photos are stored on the memory card and will still be there when you turn the camera back on. Turning off the camera is completely safe for your files.
How long does it take for the battery to drain in standby mode?
Standby mode drains the battery much more slowly than recording, but it still uses power. A full battery in standby mode will last several hours to a full day depending on the model and battery size. If you will not use the camera for more than a few hours, power it off completely.
Can I turn off the camera while it is recording?
You should not turn off the camera while it is actively recording. Doing so may corrupt the video file. Instead, press the record button to stop recording first, wait for the camera to finish saving the file, then hold the power button to turn off the camera.
What if my camera is stuck in standby and I cannot wake it up?
Remove the battery for 30 seconds and reinsert it. This will force a complete reset. Then press the power button to turn the camera on. If it still will not respond, plug it into a charger for 15 minutes and try again.