The quickest way to power down your GoPro Hero 5
Press and hold the power button on the back of the camera for three seconds until the screen goes black and the LED indicator light turns off. That's it — your Hero 5 is now powered down. The power button is the small button on the rear of the camera, just above the battery door.
If you're holding the button and nothing happens, your battery may be completely drained. Plug the camera into a USB charger for at least 30 minutes, then try again. A completely dead battery won't respond to the power button at all.
The Hero 5 will also shut itself off automatically if you leave it idle for about five minutes. This is a battery-saving feature, so if your camera seems to have turned off on its own, it was likely sitting unused and powered down to preserve battery life.
Key Takeaways
- Hold the power button on the back of the camera for three seconds until the screen blacks out and the LED light turns off.
- A completely dead battery will not respond to the power button, so charge the camera first if it won't turn off.
- The Hero 5 automatically shuts down after about five minutes of inactivity to save battery power.
- You'll know the camera is fully off when both the screen and the rear LED indicator light are completely dark.
What happens when you hold the power button
When you press and hold the power button, the Hero 5 begins a shutdown sequence. The screen will display a brief shutdown message or straightforward go dark. At the same time, the small LED light on the back of the camera will turn off. Both of these signals tell you the camera is powering down.
Don't release the button early — you need to hold it for the full three seconds. If you tap it quickly instead of holding it, the camera may enter standby mode rather than shutting off completely. In standby mode, the screen is off but the camera is still drawing power from the battery, just at a much slower rate.
The difference between standby mode and full shutdown
Your Hero 5 has two low-power states: standby mode and full shutdown. In standby mode, the screen is off but the camera is still on and will wake up quickly if you press any button. This uses a small amount of battery power continuously. Full shutdown turns off all power except what's needed to keep the internal clock running, so it drains the battery much more slowly.
If you're storing your camera for more than a few days, full shutdown is better for battery health. If you plan to use it again within the hour, standby mode is fine. To enter standby mode instead of full shutdown, press the power button once — the screen will go dark but the camera remains ready to wake up when ready.
Charging a completely dead battery
If your Hero 5 won't respond to the power button at all, the battery is completely empty. Connect the camera to a USB power source using the included USB cable. The charging port is on the side of the camera, near the battery door. You should see a small LED light turn on to indicate charging has started.
Let the camera charge for at least 30 minutes before trying to power it on. A completely drained battery may take longer to show any signs of life. Once you see the LED light or the screen flickers on, the battery has enough charge to respond to the power button. At that point, you can power it down using the three-second hold method.
Why your camera might not turn off
If you're holding the power button and the camera won't shut down, the battery is almost certainly the problem. A battery with no charge cannot respond to any button press, including the power button. This is a safety feature — the camera won't drain what little power remains by trying to process your command.
Another less common reason is a software freeze. If the camera is frozen and won't respond to the power button, try removing the battery entirely for 30 seconds, then reinserting it. This forces a complete reset. After you reinsert the battery, wait a few seconds before trying the power button again.
Extending battery life between charges
Turning off your camera completely when you're not using it is one of the best ways to preserve battery life. Every time you power down instead of leaving it in standby, you're saving power that would otherwise drain slowly over hours. If you know you won't be filming for several hours, full shutdown is always the right choice.
You can also extend battery life by turning off features you don't need. Wifi, Bluetooth, and GPS all draw power even when the camera isn't recording. If you're not using these features, disable them in the settings menu. Lowering the screen brightness also helps, though the Hero 5's screen is already quite dim to save power.
Frequently Asked Questions
How long does it take for the GoPro Hero 5 to shut down?
The shutdown happens almost when ready once you release the power button after holding it for three seconds. The screen goes black and the LED light turns off within a second or two. The entire process takes less than five seconds from start to finish.
Will my GoPro Hero 5 lose its settings if I turn it off?
No. Turning off the camera does not erase any settings, footage, or photos. All your preferences and recorded content stay saved in the camera's memory. When you power it back on, everything will be exactly as you left it.
Can I turn off the camera while it's recording?
You can press the power button while recording, but the camera will finish saving the current clip before shutting down. Don't force the shutdown by removing the battery while recording, as this can corrupt the video file. Always let the camera complete its save process.
What's the difference between turning off the camera and removing the battery?
Turning off the camera using the power button is the safe way to shut it down — the camera saves any open files and closes them properly. Removing the battery without powering down first can corrupt files and damage the camera's file system. Always use the power button unless the camera is completely frozen.
Does the GoPro Hero 5 use battery power when it's turned off?
A fully powered-off Hero 5 uses almost no battery power. The internal clock may draw a tiny amount, but it's negligible. If you're storing the camera for weeks or months, a fully powered-off camera will hold its charge far better than one left in standby mode.