GoPro cameras come waterproof from the factory, but the depth rating depends on which model you own
Every current GoPro model is waterproof without a case. The GoPro Hero 12 and Hero 11 are waterproof to 33 feet (10 meters). The GoPro Hero 11 Mini is waterproof to 16 feet (5 meters). The GoPro Max is waterproof to 16 feet. If you own an older model, check the spec sheet that came with it or look up your serial number on GoPro's website—waterproof ratings changed between generations.
The waterproof rating means the camera can survive being submerged at that depth for 30 minutes. It does not mean you can take it deeper and expect it to work, and it does not mean the camera is safe in saltwater without rinsing afterward. Saltwater corrodes the seals and metal parts if you do not rinse with fresh water within an hour of use.
Key Takeaways
- GoPro Hero 12 and Hero 11 are waterproof to 33 feet without any case; the Mini and Max models are waterproof to 16 feet.
- Waterproof rating assumes 30 minutes of submersion—going deeper or staying submerged longer voids the protection.
- Saltwater use requires rinsing with fresh water within one hour, or the seals and metal components will corrode.
- Opening the battery door, SD card slot, or USB-C port underwater will let water inside and damage the camera permanently.
- If you need to go deeper than 33 feet, you must buy a separate dive housing, which costs $50 to $150 depending on depth rating.
What "Waterproof to 33 Feet" Actually Means
The 33-foot rating on the Hero 12 and Hero 11 comes from an IP68 certification, which is an international standard for water resistance. IP68 means the camera survived a lab test where it was submerged at that depth for 30 minutes without water entering the sealed compartments. It does not mean the camera will work at 33 feet for an hour, or that it will survive 34 feet.
The rating also assumes still water. Fast-moving water, waves, or water pressure from diving deeper than the rated depth can force water past the seals. If you are snorkeling in calm water at 20 feet, you are well within the safety margin. If you are diving to 30 feet in a current or planning to go to 50 feet, you need a housing.
The waterproof rating applies only to the camera body itself. The battery door, SD card slot, and USB-C port all have rubber seals. If you open any of these underwater or in heavy rain, water will get inside and the camera will be ruined. Do not open these ports unless the camera is completely dry.
Saltwater and Freshwater Rinsing Requirements
Saltwater is harder on the camera than freshwater because salt crystals form on the seals and metal parts as the water evaporates. These crystals corrode the rubber and metal, eventually causing leaks. If you use your GoPro in the ocean, rinse it with fresh water from a tap or a freshwater rinse bottle within one hour of getting out of the water.
Rinse the entire camera, paying special attention to the seams, the battery door, and the USB-C port. You do not need to open these ports to rinse—just run fresh water over the outside. Let the camera air-dry completely before you store it or charge it. If you store a wet camera in a bag or case, mold can grow inside.
Freshwater use (lakes, rivers, pools) does not require rinsing, but it is still a good idea to let the camera dry before storing it. If you notice any water droplets inside the lens or on the screen after use, the seal may be damaged and you should contact GoPro support before using the camera again.
When You Need a Dive Housing Instead
If you plan to dive deeper than 33 feet, snorkel with the camera mounted on your head in rough water, or use the camera in a high-pressure environment like a waterfall, you need a separate dive housing. GoPro sells the Super Suit, which adds waterproof protection to 196 feet (60 meters) and costs around $80. Third-party housings from brands like Telesin and Neewer offer similar protection for $50 to $150 depending on the depth rating.
A housing is a rigid plastic or aluminum case that the camera slides into. The housing has a clear window so the lens can still see out. You seal the housing with latches or a screw-on back plate, and the housing itself is what contacts the water—not the camera. This lets you go much deeper because the housing is engineered to handle the pressure.
Housings also protect the camera from impact if you drop it or if it hits rocks. If you are doing any kind of extreme water sport—whitewater kayaking, surfing in rocks, diving—a housing is worth the cost even if you are staying within the 33-foot depth limit.
What Voids the Waterproof Warranty
GoPro's waterproof warranty covers manufacturing defects, not damage from misuse. Opening the battery door, SD card slot, or USB-C port underwater voids the warranty. Using the camera in hot springs, chlorinated pools, or other chemically treated water also voids it—these chemicals degrade the rubber seals faster than plain water does.
Dropping the camera or hitting it hard enough to crack the lens or body also voids the waterproof warranty, even if the camera still turns on. If you crack the lens, water can seep in through the crack. If you dent the body near a seal, the seal may no longer fit tightly.
If your camera gets wet inside and stops working, GoPro will not repair it under warranty. The repair cost is usually $150 to $300, or you can buy a refurbished camera for around $200. This is why it is worth being careful about opening ports and why a housing is cheap insurance if you are doing anything risky.
Testing Your Camera's Seals Before Deep Water Use
Before you take a GoPro on a dive or into the ocean, test the seals in a bathtub or pool at shallow depth. Fill a sink or tub with water, submerge the camera for one minute, and then pull it out and dry it completely. Open the battery door and look inside with a flashlight. If you see any water droplets, the seal is not tight and you should not use the camera underwater.
If the seal looks dry, close the battery door again and submerge the camera for another minute. Repeat this test three times. If water never gets inside, the seals are good. If water gets in on any test, the rubber seal may be dirty or damaged. Clean the seal with a soft, dry cloth and try again. If water still gets in, contact GoPro support—the seal may need to be replaced.
This test takes five minutes and can save you from losing a $400 camera. Do it before any trip where the camera will be in water for more than a few minutes.
Frequently Asked Questions
Can I use my GoPro in a swimming pool?
Yes, the waterproof rating covers chlorinated pools. However, chlorine degrades the rubber seals over time, so rinse the camera with fresh water after each pool session and let it dry completely before storing it. If you use your GoPro in a pool more than once a week, consider replacing the seals every six months.
What happens if water gets inside my GoPro?
The camera will likely stop working when ready or within a few hours as the water corrodes the circuit board. GoPro does not repair water damage under warranty. If this happens, your options are to buy a refurbished camera or send it to GoPro for an out-of-warranty repair, which costs $150 to $300.
Is my older GoPro still waterproof?
Older models like the Hero 10, Hero 9, and Hero 8 are also waterproof to 33 feet, but the rubber seals degrade over time. If your camera is more than three years old and has been used in water frequently, the seals may no longer be tight. Test it in a bathtub before taking it on a trip.
Do I need a case if my GoPro is already waterproof?
A waterproof case (housing) is not necessary for casual snorkeling or beach use within the 33-foot depth limit, but it adds protection from impact and lets you go deeper. If you are doing any extreme water sport or diving below 33 feet, a housing is worth buying.
Can I charge my GoPro while it is wet?
No. Always let the camera dry completely before opening the USB-C port or plugging in the charger. If you charge a wet camera, water can get inside the charging port and damage the battery or circuit board. Wait at least two hours after the camera is fully dry before charging.