GoPro Hero cameras are waterproof without a case, but the depth limit depends on which model you own
All current GoPro Hero models are waterproof straight out of the box—you do not need to buy a separate housing to use them in water. However, "waterproof" does not mean "works at any depth." Each model has a maximum depth rating, and going deeper than that rating will damage the camera permanently.
The GoPro Hero 12 Black, Hero 11 Black, and Hero 11 Black Mini are waterproof to 33 feet (10 meters). The GoPro Hero 10 Black is also rated to 33 feet. Older models like the Hero 9 Black and Hero 8 Black share the same 33-foot rating. If you own a GoPro Hero 7 Black or earlier, check your manual because depth ratings vary by generation.
The waterproof rating applies only to fresh water and salt water at normal conditions. Boiling water, high-pressure jets, and chlorinated pools can damage the seals over time, even though the camera is rated waterproof.
Key Takeaways
- GoPro Hero cameras are waterproof to 33 feet without any additional case or housing needed.
- Depth ratings are a hard limit—exceeding them will allow water inside the camera and cause permanent damage.
- The waterproof rating covers fresh water and salt water, but not high-pressure water or extreme temperatures.
- Seals can degrade over time with repeated exposure to chlorine or salt water, so rinse the camera with fresh water after each use.
How the waterproof rating is tested and what it actually means
GoPro rates its cameras using the IP68 standard, which is an international test for water and dust resistance. The "68" means the camera is dust-tight and can handle immersion in water at a specific depth for a set time. For GoPro Hero models, that depth is 33 feet for 30 minutes.
The 33-foot rating is the maximum depth the camera can safely handle. This is not a suggestion or an average—it is the point at which water pressure will overcome the seals and force water into the camera body. Going to 35 feet or 40 feet is not "a little deeper"; it is exceeding the design limit. Water will enter, and the camera will fail.
The test also assumes the camera is stationary. Rapid movement through water, such as diving or being pulled behind a boat, can increase pressure on the seals and cause failure at shallower depths than the rating suggests.
What happens to the seals over time
The waterproof rating assumes the camera is in good condition. The seals that keep water out are made of rubber and can degrade with use. Exposure to salt water, chlorine, sand, and sunscreen all wear down the seals faster than fresh water alone.
After each use in water, rinse the camera with fresh water and dry it completely before storing it. This removes salt, chlorine, and other chemicals that can harden or crack the rubber seals. If you use your GoPro in salt water regularly, inspect the seals every few months for visible cracks or hardening. GoPro sells replacement seal kits, and swapping them out is a straightforward task that takes a few minutes.
If you notice water droplets inside the lens after a dive or swim, the seals have failed and the camera needs service. Do not use it in water again until the seals are replaced.
When you need a protective case instead of relying on the waterproof rating
The 33-foot waterproof rating covers normal swimming, snorkeling, and shallow diving. If you plan to go deeper than 33 feet, you need a dive housing—a rigid protective case that extends the depth rating to 196 feet or deeper, depending on the model.
You also need a case if you plan to use the camera in high-pressure environments. Jet skis, white-water rafting, and waterfalls create turbulent water and pressure spikes that can exceed what the seals are designed to handle. A protective case absorbs that impact and protects the camera.
GoPro sells official protective cases, and third-party manufacturers make them as well. The official cases are tested and may provide to work with GoPro cameras, but they add bulk and cost. If you are only swimming or snorkeling in shallow water, the built-in waterproof rating is enough.
Freshwater versus saltwater and what each does to the camera
Both fresh water and salt water are covered by the waterproof rating, but salt water is harder on the seals. Salt crystals can lodge in the rubber seals and create tiny gaps where water seeps through. Over time, repeated salt water exposure degrades the seals faster than fresh water does.
If you use your GoPro in the ocean, rinse it with fresh water when ready after every session. Do not wait until you get home. The longer salt water sits on the seals, the more damage it does. A quick rinse with a water bottle or a hose takes 30 seconds and extends the life of the seals significantly.
Chlorinated pools are somewhere in between. Chlorine is a chemical that hardens rubber over time, but it is less aggressive than salt. Still, rinse the camera after pool use to remove chlorine residue.
Common mistakes that void the waterproof rating
The waterproof rating assumes the camera is sealed correctly. If the battery door is not fully closed, or if the USB-C port cover is loose, water will enter when ready. Before every water session, check that the battery door clicks firmly into place and that the port cover is seated all the way in.
Do not open the battery door or port cover while the camera is wet. Water can enter during the few seconds the door is open. Dry the camera completely first, or wait until you are back indoors and the camera has dried.
Dropping the camera or hitting it hard can crack the internal seals even if the camera looks fine on the outside. If your GoPro takes a hard impact, inspect it for cracks or gaps before using it in water again. A hairline crack in the body can let water in at depth.
How to care for your GoPro to maintain the waterproof seals
After each water use, rinse the entire camera with fresh water—the body, the lens, the battery door, and the port cover. Use a soft cloth to dry it, and leave it open to air dry for at least an hour before closing the battery door or port cover. Trapping moisture inside will corrode the electronics.
Store the camera in a cool, dry place away from direct sunlight. Heat and UV light can harden the rubber seals. If you will not be using the camera for more than a month, remove the battery and store it separately. A battery left inside a camera that is not in use can leak and damage the seals.
Every six months, open the battery door and port cover and inspect the rubber seals for cracks, discoloration, or hardening. If you see any damage, order a replacement seal kit from GoPro and swap them out. The process takes about five minutes and costs less than $20.
Frequently Asked Questions
Can I use my GoPro in a swimming pool?
Yes, the 33-foot waterproof rating covers pools. However, rinse the camera with fresh water when ready after use because chlorine degrades the seals over time. Do not leave the camera submerged in a pool overnight.
What is the difference between waterproof and water-resistant?
Waterproof means the camera can be fully submerged in water up to a specific depth without damage. Water-resistant means it can handle splashes and brief contact with water but should not be submerged. GoPro Hero cameras are waterproof, not just water-resistant.
Will my GoPro work if I accidentally drop it in the ocean?
Yes, as long as it is at a depth shallower than 33 feet. Retrieve it quickly and rinse it with fresh water as soon as possible. The longer salt water sits on the seals, the more damage it does.
Do I need to buy a waterproof case for shallow snorkeling?
No. The built-in waterproof rating of 33 feet is more than enough for snorkeling in shallow water. A protective case is only necessary if you plan to dive deeper than 33 feet or use the camera in high-pressure environments like waterfalls or jet skis.
Can I use my GoPro in hot water or boiling water?
No. The waterproof rating applies to water at normal temperatures. Hot water and steam can damage the seals and internal electronics. Keep the camera away from hot tubs, saunas, and boiling water.